Tuesday, February 14, 2012

Buy Today Clarke 190EN Mig/Fluxcore Gas/No Gas 220V Welder KIT

Clarke 190EN Mig/Fluxcore Gas/No Gas 220V Welder KIT

Product Description

*NEW* Clarke USA 190EN MIG/Fluxcore Wire Welder KIT plus regulator kit, helmet, welding gloves, and welding cart (220V)

This NEW in factory sealed box Clarke 190EN MIG/Fluxcore 220V Wire Feed Welder KIT is easily converted from Gas to Fluxcore welding and will easily weld 1/4 in. steel in a single pass. Electronic wire speed control and 6 variable heat settings allow you to precisely adjust the welder to your needs and is fan cooled for better performance. Operates on 220 volt electrical supply. You will be getting this NEW in factory sealed box Clarke 190EN welder along with New gas regulator kit, welding cart, welding helmet, welding gloves, roll of wire, chipping hammer, welding mask, and manual.


6 power settings for maximum welding control
Easily welds 1/4" in a single pass
Fan cooled for better performance
Solid state electronic heat control with large PC board for better wire speed control
Weld steel, aluminum, stainless, copper and cast iron, requires correct wire and gas
Operates from standard 220 VAC.
Automatic thermal safety switch prevents overload
Mig gun with full On / Off safety control.
Mig Gun is non-live with built in gas shut off.
Welds with or without gas
Tough metal casing
Input 230V, 60HZ, 25 Amps, 1 ph

    No comments:

    Post a Comment